Electronic belt balance system maintenance: electronic belt balance system only a small amount of maintenance, can achieve satisfactory use effect in a few weeks, not only the first calibration of the new installation, but also just a simple zero calibration and interval calibration, can achieve the calibration of belt balance, put into use.

1. Regular cleaning, in order to prevent the scale volume ash accumulation material, resulting in weighing is not allowed.

2. Check regularly whether there is material or foreign matter stuck in the moving part of the belt scale. The specific inspection position is: the middle position of the roller and the conveyor frame, the beam of the scale frame and the scale body.

3. If the belt runs off track, adjust it regularly to prevent inaccurate measurement.

4. Do not have external force impact scale body and sensor, maintenance personnel are strictly prohibited to stand on the belt scale or operate other equipment during maintenance.

5. Do not conduct electric welding, gas cutting and other operations on the scale body during equipment overhaul.

6. Do not cross the power cable with the signal cable when laying or in use to prevent interference.

7. The instrument should be reliably grounded with independent power supply.

8. Ensure that the weighing roller and the roller in the weighing field can operate freely, otherwise it will be replaced.

9. The speed measuring drum should be cleaned regularly to prevent sticky materials.

10. The bearing seat of the speed measuring drum should be lubricated regularly.

11. Check the top wire of the shaft sleeve of the speed sensor regularly to prevent loosening or falling off.