Small electronic truck scale how to clean? Electronic truck manufacturers for you to introduce it:

I. required tools:

Customers ready to outside, 5 tons jack a crane, 30, and 21, 18, 19, heavy socket wrench and extension rod, 12 # 15 # adjustable wrench two, 2 pounds of hammer and 10 pounds of big hammer, small crowbar, 6 inch screwdriver clubs, small a word each word a, level, digital multimeter, number of sleepers or natural wood, and butter.

Others: electric soldering iron, electric adhesive tape, diagonal pliers, etc.

Small electronic truck scale

Ii. Cleaning steps

After arriving at the site, check whether the instrument, printer, computer communication is normal, check whether the sensor air balance output millivolt signal, insulation is normal, if there is a problem, put forward solutions, turn off the power, the power plug from the socket.

Three, sensor and fittings removed from the base plate, began to clean up the foundation of sundry, especially the spacing device, fitting, base plate, a scale body lap, after clean, check the line fittings, sensor and total signal line to see if there is any breakage, if you have to replace or wound, then fitting and simulator, on the base plate in place, will balance the body after falling, change back to the sensor, adjust the sensor, after vertical cable and main cable connection sensor, to connect ground, if the ground wire is broken and must use of other no less than 8 mm square shares soft copper wire connection is good, after all the connection and the cover plate processing, electricity test instrument display is normal, Adjust the force of the sensor, adjust the Angle difference, and use the weight to correct the customer.